Overview
These instructions are for installation of TG9387and TG138 Back-to-Back and Single-Sided Non-Locking Ladder Pulls for the following mounting and style versions:
Glass door mount
Wood door mount
General information
- dormakaba requires use of tempered laminated or tempered monolithic glass.
- dormakaba glass hardware is not suitable for harsh environment; for example, applications where chemicals (e.g. chlorine) are used such as indoor swimming pools, saunas, or salt-water pools.
- Never move sliding panels faster than walking speed and always stop the door manually before it reaches end position.
- Do not swing/slide doors with excessive force. Ensure proper installation of limiting stop to prevent door from opening too far.
Intended use
- For swinging/sliding doors in dry indoor areas only.
- For manual slow opening and closing only.
Door requirements/fittings/mounting
- When adjusting glass components, always adhere to the required clearance for the respective hardware. Adjust clearance so glass does not come in contact with any hard surfaces such as glass, metal or concrete.
- Do not use excessive force when installing the glass (avoid over tightening screws.)
Requirements for glass panel
- dormakaba requires use of fully tempered glass, which complies with ASTM C 1036 and ASTM C 1048. Secondary heat soaking processes are recommended but not required. This applies to both tempered monolithic and tempered laminated glass.
- Clamping area must be flat and uncoated (no self-cleaning coating!)
- Never use glass with conchoidal fractures and/or damaged edges.
Safety instructions
- Always wear protective clothing.
- Only properly qualified and specially trained staff are authorized to mount dormakaba glass hardware.
- Never clamp metal fitting hardware directly to glass surface
Symbols used - Safety/Installation
CAUTION: Mounting components must meet the requirements of substructure/wall and door weight. Please read the technical information for fittings.
WARNING: Risk of breaking glass. When installing the door, support the door panel with a block of wood or a similar object.
Maintenance, care, repair
- Immediately replace damaged parts.
- Always use original dormakaba parts.
- Clean clamping area with alcohol-based standard commercial cleaning agent before mounting the glass hardware.
- Use a damp cloth for occasional cleaning.
- Always use silicone - and oil-free cleaners (e.g. acetone).
- Check glass hardware at regular intervals for proper positioning, smooth operation and correct adjustment.
- High traffic door systems require inspection by properly qualified staff (specialized companies or installation firms.)
Disposal
Disposal in accordance with local, state and national regulations
Tools required
| 9/32” [7] drill bit for wood doors (back-to-back) | drill |
| 7/32” [5] drill bit for hard wood doors (single sided) | drill |
| 13/64” [5] drill bit for softwood doors (single sided) | drill |
| 1/8” hex key | |
| 3/16” hex key |