Description

A User Access Code should be de-activated during a User’s vacation or if you created a code but have not assigned it to a User. Codes that may be needed in the future should be de-activated rather than deleted.

Resolution

Required User Level: Master, Manager

1. Put the lock into Pushbutton Programming Mode.
2. Enter the command to deactivate User Access Codes: 400#
3. Enter the User ID location, e.g., 400#023#, where 023 is the specific User ID.
4. Example of complete entry: 400#023#
5. Press # to indicate the end of programming.
6. The User Access Code is now de-activated.

Applies To

E-Plex 2000 Series Locks
PowerPlex 2000 Series Locks