Question How to delete user access codes in E-Plex 2000 and PowerPlex 2000 Series? |
Answer User Access Codes should be deleted if no longer needed. This frees the numbers to be assigned to another user. Codes that may be needed some time in the future should be de-activated rather than deleted. Required User Level: Master, Manager J-1 Put the lock into Pushbutton Programming Mode. J-2 Enter Command 200# to delete a User Access Code. J-3 Enter the ID location NNN#, where NNN is the specific User ID location. J-4 Example of complete entry: 200 #023#. J-5 Enter another # to indicate the end of programming. By deleting a User ID location, you have now also deleted a User Access Code, allowing you to assign that number to another user if you wish. |