How to add/modify service user access code in E-Plex 2000 and PowerPlex 2000 Series?

Question

How to add/modify service user access code in E-Plex 2000 and PowerPlex 2000 Series?

Answer

A Service User is any person who needs access to the lock for a limited time period in order to perform a service, such as painting or repairs in the room or area. A Service User Access Code allows the service person to enter, exit and re-enter using that code for a certain number of hours.

Required User Level: Master, Manager

I-1 Put the lock into Pushbutton Programming Mode.

I-2 Enter Command 102# to add/modify a Service User Access Code.

I-3 Enter the Service User ID location (a three-digit number you have on a list that you should carry with
      you) followed by #, for example 025#.

I-4 Enter UUUUUUUU#, representing a User Access Code of between 4 and 8 numbers depending on
      the length of Access Code that you selected in Procedure 1 on page 7. For example, if your code
      length is 4 digits, it could be 2240#.

I-5 Enter the code 2240# again.

I-6 Now enter the number of hours, programmable between 01 and 24, for example 06. If you enter a
     Service Access Code of 00, you can only enter the door once. If the door shuts upon exiting, you will
     not be able to re-enter. This type of access is called a “one-shot” code. 

I-7 Example of Complete Entry: 102#025#2240#2240#06#.

I-8 Enter another # to indicate the end of programming.
I-9 The Service User Access Code 2240 will now work in that door, with all the access privileges assigned to
      a Service User for a period of 6 hours from the time the Service User enters his Access Code.