How to add/modify a manager access code in E-Plex 2000 and PowerPlex 2000 Series?

Question

How to add/modify a manager access code in E-Plex 2000 and PowerPlex 2000 Series?

Answer

Each time you add a Manager access to a door, you must program the door with a Manager Access Code . If you change the Access Code for an existing Manager, the procedure is the same.

Required User Level: Master

H-1 Put the lock into Pushbutton Programming Mode

H-2 Enter command 101# to add / modify a Manager Access Code

H-3 Enter the User ID location (a three-digit number you have on a list that you should carry with you)
       followed by #, for example 024#.

H-4 Enter UUUUUUUU#, representing a User Access Code of between 4 and 8 numbers, depending on
       the length of Access Code that you selected in Procedure 1 on page 7 . For example, if your code
       length is 4 digits, it could be 1224#.

H-5 Enter the code 1224# again.

H-6 Example of Complete Entry: 101#024#1224#1224#. 

H-7 Enter another # to indicate the end of programming.

H-8 The Manager Access Code 1224 will now work in that door with all the access privileges assigned to
        a Manager User.
H-9 Manager Users can open the door by just entering the Access Code without the # signs, or put the
       lock into Pushbutton Programming Mode by entering # before and after their Access Code.