Description

When a user no longer requires access, delete their User Access Code. This frees the code number for assignment to a new user.

Resolution

Required User Level: Master, Manager

1. Put the lock into Pushbutton Programming Mode.
2. Enter the command to add or modify a User Access Code: 100#
3. Enter the User ID location (three-digit number) followed by #: e.g., 023#
4. Enter the User Access Code (4–8 digits depending on procedure settings) followed by #: e.g., 1024#

5. Re-enter the same code for confirmation: 1024#

   Example of complete entry: 100#023#1024#1024#

6. Press # to indicate the end of programming.
7. The User Access Code is now active and grants all access privileges assigned to that user.

Additional Notes

• De-activating an old code does not allow you to add a user with the same number. De-activation should only be used temporarily, e.g., when the user is on vacation.
• User ID locations are three-digit numbers assigned by the Master or Manager. Maintain an accurate list of ID locations and their assigned users for proper lock programming.

Applies To

E-Plex 2000 Series Locks
PowerPlex 2000 Series Locks