Description

An Access User credential can be temporarily deactivated rather than deleted. This is useful when access must be suspended, such as during a user’s vacation. The credential can later be easily reactivated without reprogramming the user.

Resolution

Required User Level: Master

1. Put the lock into LearnLok™ Pushbutton Programming Mode: 
   # Master PIN #
2. Enter command 300# to deactivate or reactivate an Access User credential. The user’s PIN or card is not required.
3. Enter the Access User’s ID location (001–300), followed by #. 
   Example using User ID 023: 
   300# 023# # 

This completes programming and reactivates the previously deactivated Access User credential.

Applies To

E-Plex 36xx, 37xx, 56xx, and 57xx Series Locks