Description

Manager User credentials should be deleted from the lock if no longer needed since there is no expiry. This allows this ID location to be assigned to another user. Credentials that may be needed again sometime in the future should be just de-activated rather than deleted.

Please refer to the steps below if User credentials are needed to be deleted. 

Resolution

Required User Level: Manager

1. Put the lock into “LearnLokTM” Pushbutton Programming Mode -> # Master PIN #
2. Enter Command 201# to delete a Manager User Credential whether it is card only credential or PIN & card credential; you do not need this person’s card and/or the PIN to delete. 

3. Enter the ID location NNN#, where NNN is the specific User ID location from 001 to 300; we will use the ID location 015 in this example. 

   Enter a last # to indicate the end of programming. 
   Example of Complete Entry for user ID=015: 
   201#015# #. 
   Now this user’s credential will not work in the lock anymore. This allows you to assign another user to this deleted User ID location if you wish.

Applies To

E-Plex 36xx/37xx/56xx/57xx Series Locks