Description

Access User credentials should be deleted if they are no longer needed. Deleting a credential frees the User ID location to assign it to another user. For credentials that may be required later, consider de-activating them instead of deleting.

Resolution

Required User Level: Master, Manager

1. Put the lock into “LearnLokTM” Pushbutton Programming Mode.
2. Enter command 200# to delete an Access User credential. This works for both Card-Only and PIN & Card credentials. You do not need the user’s card or PIN to delete.
3. Enter the Access User ID location NNN#, where NNN is the specific User ID location (001–300). Enter a final # to indicate the end of programming.
   Example: To delete user ID 023: 200#023# #
   After this, the user’s credential will no longer work, and the ID location can be reassigned.

Applies To

E-Plex 36xx, 37xx, 56xx, and 57xx Series Locks