Description

 A User Access Code can be deactivated rather than deleted. This is useful for inactive codes that may be needed again in the future.

Resolution

Required User Level: Master, Manager

1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 400# to de-activate User Access Codes.
3. Enter the code 400 #NNN #, where NNN is the specific User ID location, 023 for example.
4. Example of complete entry: 400 #023#.
5. Enter another # to indicate the end of programming.
6. You have now de-activated the User Access Code assigned to 023.

Applies To

E-Plex 30xx and 50xx Series Locks