Description

A Service User Access Code is automatically deleted from the lock at the end of its specified length of time. 

If needed, refer to the procedure below if you want to delete the code earlier than the specified expiry time.

Resolution

Required User Level: Master

1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 202# to delete Service User Access Code.
3. Enter the ID location NNN#, where NNN is the specific Service User ID location, 025 for example
4. Example of complete entry: 202#025#.
5. Enter another # to indicate the end of programming.
6. You have now deleted a Service User ID location, and (indirectly) his access code, allowing you to assign that ID location to another Service User if you wish.

Applies To

E-Plex 30xx/50xx Series Locks