How to Add/Modify Service User Access Code in E-Plex 30xx/50xx?

Question

How to Add/Modify Service User Access Code in E-Plex 30xx/50xx?

Answer

A Service User is any person who needs access to the lock for a limited time period in order to perform a service, such as painting or repairs in the room or area. A Service User Access Code allows the service person to enter, exit and re-enter using that code for a certain number of hours, up to a maximum of 24 hours

Required User Level: Master, Manager

1. Put the lock into Pushbutton Programming Mode.
2. Enter Command 102# to add / modify a Service User Access Code.
3. Enter the Service User ID location (a three-digit number you have on a list that you should carry with you) followed by #, for example 025#.
4. Enter UUUUUUUU#, representing a User Access Code of between 4 and 8 numbers depending on the length of Access Code that you selected in Procedure 1 on page 7. For example, if your code length is 4 digits, it could be 2240#.
5. Enter the code 2240# again.
6. Now enter the number of hours, programmable between 01 and 24, for example 04. If you enter a Service Access Code of 00, you can only enter the door once. If the door shuts upon exiting, you will not be able to re-enter. This type of access is called a one-shot code.
7. Example of Complete Entry: 102#025#2240#2240#04#
8. Enter another # to indicate the end of programming.
9. The Service User Access Code 2240 will now work in that door, for this Service User for a period of 4 hours from the time the Service User enters his Access Code the first time.