General rules for User Code and Programming in E‑Plex 30xx and 50xx series locks

• Master and Manager Codes can do two different things: 
  • Open the door by entering the Access Code without # signs. 
  • Put the lock into Pushbutton Programming Mode by entering # before and after their Access Code.
• Each user (Manager User, Service User or Access User) occupies one of the available 300 locations in the user table.
• By default, user 000 is the Master User.
• The M-Unit User is outside of the user table (only applicable with “E-Plex Standard” PC software use).
• Users have a 15-second period to enter the entire key sequence, and 5 seconds between pressing each pushbutton number. If they pause longer than 5 seconds between each pushbutton pressed, or exceed the 15-second period to enter the total sequence, the lock: 
  • aborts the current programming sequence 
  • automatically exits the programming state 
  • sends the user a ‘Keypad Timeout’ feedback message

Note: Correct errors during a command sequence. If an invalid entry occurs, recover from the mistake by entering the (*) key, which will clear all entries made from the beginning of the current command sequence, and will reset the 15-second time limit for entering the code. In this case, you still have 15 seconds from the first number entered to enter the whole code.