Description

Procedure to setup a Lock Function as Entry lock (04), Storeroom lock (07), Residence lock (08) or Privacy lock (15):

• All lock types (cylindrical, mortise, exit device operators, etc.) coming out of the factory will be in Entry lock function (04) mode by default. Performing a hard reset as explained in the Operations Manual will always reset the lock to an Entry lock function.
• For any lock function other than the Entry lock, you must change the lock function and setup the desired lock function - 07 (for E-Plex 2xxx/5xxx only), 08 or 15. This can be done only at the lock pushbuttons (and not through the software) while the lock is still in factory mode with the Master code as 12345678.

Important: Anytime a lock has been reset via a hard reset, this set-up procedure will have to be performed unless the lock is to remain as an entry lock.

Resolution

Required User Level: Master

1. Ensure that the lock is in factory mode; if not, reset the lock as per instructions in the respective Operations Manual to hard reset the lock to factory default mode. 
2. Enter the lock programming mode using the factory Master PIN: #12345678# 
3. [Skip this step for Storeroom (07) locks]. 
   For a Residence (08) or a Privacy (15) lock, enter the command “013#” to tell the lock that it contains a privacy thumbturn. Then flip the thumbturn once & verify the Green LED flashes once. 
4. Finally enter another command code to actually define the lock’s operating lock function as - Storeroom lock (07), Residence Lock (08) or Privacy lock (15); enter only one of the three lock function command codes (07, 08 or 15):  
    
   • 011# 15# for Privacy lock, or
   • 011# 08# for Residence lock, or
   • 011# 07# for Storeroom lock [for E-Plex 2xxx/5xxx locks only] 
      
5.  Enter # to end this lock programming session.
   • From now on the lock will perform as setup here as a Privacy lock, a Residence lock, or a Storeroom lock etc. 
   • At this point, the Master PIN is still the factory default of 12345678, which must be changed to actually use the lock. 
      
6. Change the factory default Master PIN from 12345678 to any other 8 digit number for further
   programming as described in the Operations Manual.

Applies To

E-Plex 2xxx and 5xxx Series Locks