Lock Function Options for E-Plex 2xxx/5xxx Series

The E-Plex 2xxx/5xxx Mortise and thumbturn locks can be configured on-site to work in various lock functions, which are relevant to those defined by BHMA (Builders Hardware Manufacturers Association). All E-Plex 2xxx/5xxx products are shipped in factory default mode, and are configured as an Entry lock function (04). 

This section will help you change your lock from an Entry lock into another function as listed for each mechanical locking configuration, if required. The options available in a given lock are determined by the respective lock’s mechanical locking configuration as noted below. 

E-Plex 2xxx/5xxx Cylindrical (without thumbturn) and Exit Trim Configuration 

• Entry Lock Function with Passage Enabled (04) 
• Storeroom Lock Function (07)
  • Note: Not applicable to E-Plex 5200 & 5700 

E-Plex 2xxx/5xxx Cylindrical (with thumbturn) 

• Entry Lock Function with Passage Enabled (04) 
• Privacy Lock Function (15) 

E-Plex 2xxx/5xxx Mortise with Deadbolt 

• Entry Lock Function with Passage Enabled (04) 
• Residence Lock Function (08) 
• Privacy Lock Function (15) 

E-Plex 2xxx/5xxx Mortise without Deadbolt 

• Entry Lock Function with Passage Enabled (04) 
• Storeroom Lock Function (07)
  • Note: Not applicable to E-Plex 52xx & 57xx

Applies To

 E-Plex 2xxx/5xxx Series Locks