1. Overall
| 1 | Cable |
| 2 | Cable height guides |
| 3 | Wheels |
| 4 | Cable clamps |
| 5 | Cable locking clamps |
2. Install synchro track wheels
| 1 | Place wheels toward ends of track. |
| 2 | Move to correct position. |
| 3 | To engage plates, rotate inside track. |
| 4 | Tighten screws. • Use 4mm hex key at 2.2 ft lbs [3Nm] of force. |
3. Install cable height guides
| 1 | Loosely secure cable height guides to ends of carriers. |
| 2 | Secure on side of carrier closest to closing edge of door |
4. Install cable clamps
| 1 | Secure cable clamp pin and cable clamp pin guide into carrier as shown. |
| 2 | Secure on side of carrier closest to closing edge of door |
5. Install cable
| 1 | Disassemble cable and tensioning spring parts. |
| 2 | Place felt grease/lubricant onto cable tensioning rod. |
| 3 | Thread rod through cable height guide as shown. |
| 4 | Secure spring to rod in the following order: • Nut - Flat washer - Spring - Flat washer - Guide • Use an 8mm wrench to tighten nut. |
6. Thread cable
| 1 | Thread cable around wheels in direction as shown. |
7. Install cable locking clamps
| 1 | Feed end of cable through other cable height guide. |
| 2 | Secure with two cable locking clamps. |
| 3 | Hold cable tight and tighten clamp with flat head screw driver. NOTE: Ensure there is no slack in the cable |
8. Cable tension adjustment

| 1 | Adjust tension in cable. |
| 2 | Use 8mm wrench to rotate nut and compress or expand spring. |
| • Compress (CW) = more tension • Expand (CCW) = less tension • Minimum spring compression = 1” [26] |
9. Door gap
| 1 | Ensure 1/4” [6] gap between the doors. |
10. Secure cable to cable clamps
| 1 | Secure cable to rollers carriers. |
| 2 | Pinch cable between cable clamp pin guide and cable clamp pin plate. |
| 3 | Secure with nut. |
11. Engaging anti-jump
ENSURE ROLLERS AND TRACK ARE FREE OF DEBRIS.
| 1 | Adjust cable height. |
| 2 | Loosen screws. |
| 3 | Raise or lower height guides to desired height. |
| 4 | Re-secure at 2.2 ft lbs [3Nm] of force. |
12. Install cover
| 1 | Place foam tape along inside edge of cover. |