Lock Operating Conventions in Auditcon Models 52 & T52
Updated
Question
What are the Lock Operating Conventions in Auditcon Models 52 & T52?
Answer
The power source for the Auditcon 2 Lock Series is PowerStarTM Technology. With this technology an internal generator is used to create all necessary power. Important Note: The lock must be manually powered before each operation by briskly turning the dial back and forth .
To clear a combination or keystroke, press the * key.
If the bolt is not retracted within 4-6 seconds after a valid opening combination is accepted, the lock will “relock”.
Please note the following operational differences based on the type of bolt you have installed:
Dead Bolt (Manual Locking) Technology: There is a “Home” position for the dial on the lock that is directly related to the manual retraction or extension of the bolt. In the “HOME” position, the lip of the dial will cover the red “open lock” indicator. The dial must be positioned here on a lock “Open’’ operation before you can successfully open the lock. The dial must be turned to the right (CW) to retract the bolt and unlock the lock. The dial must be turned to the left (CCW) to extend the bolt and lock the lock. The lock may not open if more than a 5 lb. force is applied to the end or side of the bolt.
Slide Bolt (Auto Locking) Technology: Once a combination has been entered and accepted, the lock bolt movement works in conjunction with the bolt works of the container. When the bolt works are disengaged to open the container, the lock bolt will slide into the “unlocked” or retracted position. Once the bolt works are extended to the locked position, the lock bolt automatically slides into the “locked” position. The lock will not open if force is applied to the end or side of the bolt.