Add Supervisor(s) or User(s) in Auditcon Models 252 & 552

Question

How to Add Supervisor(s) or User(s) in Auditcon Models 252 & 552?

Answer

The Master User can add an Access User to the lock in Independent mode or can add a Supervisor to the lock in Super/Sub mode. A Supervisor can add a Subordinate User to the lock in Super/Sub mode. Subordinate Users will be assigned to the Supervisor who added them.

Note: When Time Delay has been defined in the lock, certain User IDs are designated for Time Delay Override. For a Model 252 lock, User ID 20 can perform this action. For a Model 552, Users 90-99 have this ability

Caution: Keep in mind when adding users to the lock that a Supervisor cannot open the lock in Super/Sub Mode and a user that has been added to perform Time Delay Override cannot open the lock when a Time Delay has been set in the lock.

1. Press # and then 3.
2. Enter the Master User combination or Supervisor combination.
3. Enter the new Supervisor or User ID.
4. Enter the new Supervisor or User ID again for verification.
5. If additional Supervisors or Users are to be added, repeat Steps 3-4 until all Supervisors/Users have been added.
6. Enter 00 to end operation.

Note: The default PIN assigned to a new User or Supervisor ID is “502550”. A user must change this default PIN before any lock operations can be performed. Refer to the “Change PIN” section for instructions on changing a User PIN.