Program the Lock using Auditcon 2 Series Software

Question

How to Program the Lock using Auditcon 2 Series Software?

Answer 

If you choose the “Program the Lock” menu option from the Auditcon 2 Series PC software, you can define the following data in an Auditcon 2 lock:

• Lock ID
• Access Mode
• Lock Mode
• Sound ON/OFF
• Reporting Capabilities
• Delay Time and Delayed Opening Window
• Users

Notes: 

• The Program Lock operation requires a red SA key that has been properly prepared at the PC using the Auditcon 2 Series Software. 
• If you choose to set the time in the lock using the software, the operation requires a teal colored B key (P/N 202023), prepared at the PC using the Auditcon 2 Series Software, rather than a red SA key.

If you are programming a Model 552 lock, you can also set the Date & Time in the lock and define Time Windows.

Steps to program the lock

1. Press # and then 8. A green and red flash will display.

2. Enter the Master User combination. Short red flashes begin to display. 

   • From the time these flashes begin, you have 10 seconds to properly place and hold the prepared Smart Key (SA or B key) to the lock key reader. 
   • If you do not properly hold the key to the lock key reader within the 10 second period, short red flashes followed by three long red flashes display to indicate an error and you will need to re-key the operation. 
   • If the Smart Key has not been properly initialized, three long red flashes display.  
      

   Helpful Hint: For Round housing lock models, press down on the top of the key with your thumb, holding the key at an angle against the key reader to ensure that the key makes proper contact with the key reader. For Vertical housing lock models, press and hold the key directly against the key reader

    

3. Ensure that the key remains connected to the key reader until the lock has completed the upload. Upon completion, simultaneous green and red flashes display.