Unlock with Time Delay Set in Auditcon Models 252 & 552

Question

How to Unlock with Time Delay Set in Auditcon Models 252 & 552?

Answer 

Note: A change in delayed opening will not take effect until the next opening

1. For a Dead Bolt, place dial in the HOME position.

2. Enter a valid opening combination. Wait for the time delay to expire. (While powered, the lock will display two red flashes approximately every four seconds for the duration of the delay. There may be a short pause before the flashes start.)  

   ---

   Note: If you have a Time Delay Display unit (P/N 307025) installed, the display unit will count down to the end of the time delay period and will count up to the end of the window period.

   ---

   If the lock is powered when the time delay has expired, the lock will begin to display two green flashes, each accompanied by a beep, every four seconds. This indicates that the delayed opening window has begun.

3. When the delayed opening window has begun, power the lock and re-enter the same combination. 

   If operating in Single User access and the combination is entered successfully, the lock indicates that it is ready to open by displaying the following:
                    Dead Bolt - 1 slow green flash
                    Slide Bolt - Continuous green flashes ... for approx. 5 seconds
   If operating in Dual User access, simultaneous green and red flashes display.

4. For Dual User access, enter the second valid combination. If the combination is entered successfully, the lock indicates that it is ready to open by displaying the following: 
                  Dead Bolt - 1 slow green flash G 
                  Slide Bolt - Continuous green flashes G ... for approx. 5 seconds
5. For a Dead Bolt , dial right (clockwise) until the lock bolt is retracted. For a Slide Bolt, rotate the container handle to unlock.

Note: The lock will not accept any # keypad commands during a delayed opening. If you attempt to enter a combination other than that of a TIme Delay Override User during a time delay period, the LED will display three red flashes to indicate an error.