Shelve lock using Super Master Combination in Auditcon

Question

How to Shelve lock using Super Master Combination?

Answer

This operation places the lock in Shelved Mode where most lock information is returned to the factory default settings. The only information retained from the operational mode is the audit information and the Super Master Combination.

1. For a Dead Bolt, place dial in the HOME position.
2. Press # and then 0.

3. Enter the Super Master User combination (i.e., ID “00” followed by the six-digit PIN). The lock indicates that it is ready to open by displaying the following:
   Dead Bolt - 1 slow green flash
   Slide or Swing Bolt - Continuous green flashes ... for approx. 5 seconds

   ---

   Note: A green flash followed by three red flashes indicates that the lock does not have enough power to perform the shelving operation

   ---

4. For a Dead Bolt, dial right (clockwise) until the lock bolt is retracted. For a Slide or Swing Bolt, rotate the container handle to unlock.

   The lock is now shelved and will open by entering any valid User ID for the lock model (except “00”) followed by 502550.