Battery Box
Introduction
The Battery Box provides power to the System.
Connect the Battery Box
The Battery Box can be used to power the System. Simply connect the Battery Box into the BAT port of the safe lock. For multi-lock Systems, we recommend a Battery Box for every 2 safe locks.
Mount the Battery Box
Mount the Battery Box to the interior safe wall via the holes and screws provided; refer to the diagram below.
Battery Replacement
Ensure batteries are new and in good condition; leak- ing batteries can cause damage to components and can also cause serious bodily harm.
Batteries must be replaced a minimum of once per year; refer to the diagram below.
Specifications
Battery
2 x 9V DC alkaline batteries (EvereadyTM or DuracellTM strongly preferred)
Environmental
• Operating & Storage Temperature Range: For UL compliance, this product was verified for operation at 32-122 °F (0-50 °C)
• Relative Humidity Range: 0 - 95% non-condensing
Note: The Battery Box is not UL evaluated.
AC/DC Power Supply
Introduction
The Power Supply is used as the primary power source for a CenconX System.
Do not apply power before completing all steps of an installation; doing so may damage the components. Ensure all power supplies are plugged into grounded electrical receptacles that comply with local building code(s). When using this transformer, it is to be installed in compliance with NFPA 70 and all applicable electrical codes.
Connect the Power Supply
Feed the power cable through a hole in the safe. The hole needs to be big enough to fit the 4-pin connector that connects to the BAT port of the safe lock. Connect the adapter portion of the power supply into an electrical receptacle and the other end into the BAT port of a safe lock.
Specifications
Cables
• 1x 26 AWG 6" cable (43109-3)
• 1x 26 AWG 18" cable (41040-1) at an additional cost
Environmental
• Operating & Storage Temperature Range:
For UL compliance, this product was verified for operation at 32 122 °F (0-50 °C)
• Relative Humidity Range: 0 - 95% non-condensing
Electrical Rating
• Listed Switch Mode Power Supply; (QQGQ) Manufactured PHIHONG P/N PSC12R-090
• Primary Rated: 100-240 VAC, 50-60Hz, 0.25, 0.5A
• Secondary Rated: 9V DC, 1.33A