Configure a multi-lock system for Auto Open using a Display Keypad in LA GARD 700 Series Lock

Question

How to configure a multi-lock system for Auto Open using a Display Keypad in LA GARD 700 Series Lock?

Answer

Note: Review sections 3.15.1 “Aspects of Auto Open” and 3.15.1.1 “Auto Open Interactions with other features” before configuring Auto Open. 

Ensure that the target lock has been installed prior to beginning the Auto Open setup 

Follow these steps to configure a multi-lock system for Auto Open using a Display Keypad:

1. Enter an Authorized User ID and Combination.
2. Navigate through the Main Menu and select “System”
3. Select “Locks” from the sub-menu.
4. Select “Auto Open” from the sub-menu.
5. If more than two locks are installed, you will be asked to select a lock. To choose a target lock for Auto Open, press the corresponding number on the Keypad. Note: Lock 1 is not available to be selected as the Target Lock.
6. On the display, you will see the current Lag Time setting for the Target Lock. Use the Keypad to enter a new Lag Time (from 0-60 seconds). A value of 0 indicates that the lock is not part of an Auto Open Sequence.
7. The display will indicate “Success Lag time Set”. The Keypad will beep three times and flash a green LED.
8. Repeat steps 3 to 6 for any additional Target Locks and Auto Open Sequences.