Auto Open Feedback in LA GARD 700 Series Lock

When a user attempts to open a target lock, the Auto Open Sequence is initiated, and the following behavior is observed:

1. Auto Open sequence begins after the user selects the Target Lock and executes a successful Open Lock command:
   • Lock: Lock 1 will open
   • Display: “Lock 1 Open”
   • Keypad: Green LED flashes 3 times, with 3 high beeps (if buzzer enabled). Any keypresses will be rejected with a corresponding red LED flash and buzzer beep.
2. After approximately 3 seconds:
   • Lock: Lock 1 will open
   • Display: Displays the time and date, then “In Auto Open Sequence”
   • Keypad: Any keypresses will be rejected with a corresponding red LED flash and buzzer beep
3. After Approximately 2 seconds or less:
   • Lock: All Locks are locked
   • Display: “In Auto Open Sequence”
   • Keypad: Any keypresses will be rejected with a corresponding red LED flash and buzzer beep
4. After approximately 5 seconds or less:
   1. Lock: All Locks are locked
   2. Display: Blank screen, “In Auto Open sequence” will reappear if a key is pressed
   3. Keypad: The keypad will go to sleep. Any keypresses will be rejected with a corresponding red LED flash and buzzer beep
5. At the end of the Lag Time:
   1. Lock: The target lock will open
   2. Display: “Lock X Open”, where X represents the Target Lock being opened
   3. Keypad: Green LED flashes 3 times, with 3 high beeps (if buzzer enabled). Any keypresses will be rejected with a corresponding red LED flash and buzzer beep.
6. After approximately 3 seconds:
   1. Lock: The Target Lock will lock
   2. Display: Displays the time and date
   3. Keypad: Operates normally
7. Auto Open sequence ends