The function Parallel Mode allows you to determine whether the door locks operate in Parallel Mode (enabled) or not (function disabled).
– In the factory settings, the Parallel Mode is disabled.
– The Parallel Mode can only be enabled and disabled when all locks are reset to the factory setting. Otherwise, an error message appears during activation or deactivation.
– The Parallel Mode is only valid for the door locks. Inner compartment locks can not be operated in Parallel Mode.
– In Parallel Mode enabled, the Opening Codes for all door locks are identical. In other words, a code change leads to the identical change of the corresponding Opening Codes in all locks.
If door lock 1 is opened with the Opening Code OCap in Parallel Mode enabled, all valid Opening Codes can be used for the second door lock, except OCap. For opening any further door locks, all valid Opening Codes can be used, except the previously used Opening Code.
– The Parallel Mode can only be enabled or disabled in the settings for lock 1 and is valid for all other door locks.
Authorization: Factory code OCa1 “10203040” (or "0010203040" with ID+PIN mode)
Requirement: System status ‘Unlocked’ (door locks and door bolt open) and system reset to factory settings and addressed.
To enable or disable the function Parallel Mode, proceed as follows:
1. Wake up display (if necessary) and access menu. | ||
2. Select and confirm the menu option “Settings”. | ||
3. Select and confirm menu option “Settings Lock 1”. | ||
4. Enter and confirm Master Code of lock 1. | ||
5. If the function Parallel Mode is disabled, select and confirm the menu option “Settings L1 Other”. | ||
6. Select and confirm menu option “Other L1 Parallel Mode” or “Settings S1 Parallel Mode”. | ||
7. Select and confirm desired setting. | ||
The selected setting is stored. The input unit returns to the menu option “Settings S1 Parallel Mode”. You can now configure other settings or return to the standard mode display. | ||