Master reset using a Display Keypad LA GARD 700 Series Lock

Question

How to perform a Master reset using a Display Keypad LA GARD 700 Series Lock?

Answer

This method requires knowledge of the Master combination. In a multi-lock System, Lock #1 must be reset last. Follow these steps to perform a Master reset using a Display Keypad:

1. Enter the Master ID and Master Combination.
2. From the Main Menu, navigate through the options to select “System”.
3. From the options, select “Locks”.
4. Select “Reset”.
5. All locks installed within the System will be listed. An X indicates no lock installed. Press the corresponding number key to select a Lock.
6. After resetting all other locks, or if the primary lock is the only one installed, “Confirm Reset” will appear on screen. Select “Yes”. “Success” will appear on screen when the lock is reset. If the primary lock is reset, the Keypad will then reset. If other locks are reset, the Keypad will return to the Locks section on screen.

Note: An ‘X’ in the lock selection screen indicates the lock cannot be reset. The lock might not be connected, or not installed, or is the primarily lock and the only one that can be reset. When the primary lock is the only lock installed, a prompt will appear instead of lock selection to confirm the reset.