Paxos - Enabling/Disabling Parallel Mode
The Parallel Mode function defines whether door locks operate together in parallel or independently.
When Parallel Mode is enabled, all door locks operate in Parallel Mode.
When Parallel Mode is disabled, each door lock operates independently.
By default, Parallel Mode is disabled in the factory settings.
Configuration rules and behavior:
You can enable or disable Parallel Mode only when all locks are reset to factory settings.
If the locks are not reset, the system displays an error message during activation or deactivation.Parallel Mode applies only to door locks.
Inner compartment locks do not support Parallel Mode.When Parallel Mode is enabled, all door locks share identical Opening Codes.
Any change to an Opening Code applies simultaneously to all door locks.If you open door lock 1 using the Opening Code OCap, the system prevents reuse of OCap on the next door lock.
For each subsequent door lock, you must use any other valid Opening Code, except the code used on the previous lock.You can enable or disable Parallel Mode only in the settings for lock 1.
The setting then applies to all other door locks.
Authorization: Factory Code OCa1 “10203040”
(or “0010203040” when using ID + PIN mode)
Requirement:
System status must be Unlocked (door locks and door bolt open).
All locks must be reset to factory settings and addressed.
Steps to enable or disable the function Parallel Mode
1. Wake up the display if necessary and access the menu. | ||
2. Select and confirm the menu option Settings. | ||
3. Select and confirm menu option “Settings Lock 1”. | ||
4. Enter and confirm Master Code of lock 1. | ||
5. If the function Parallel Mode is disabled, select and confirm the menu option “Settings L1 Other”. | ||
6. Select and confirm menu option “Other L1 Parallel Mode” or “Settings S1 Parallel Mode”. | ||
7. Select and confirm desired settings
| ||
The selected setting is stored. The input unit returns to the menu option “Settings S1 Parallel Mode”. | ||