Paxos - Deleting or Changing Existing Codes

Changing codes: Existing codes can only be changed or deleted by the code holder, the Master Code or the Mutation Code.

AS384 Management-Suite Software
In Extended Mode of the locking system with code format ID+PIN, other codes, in addition to the Master Code and Mutation Codes, can also be assigned the right to change and delete foreign codes, by using the AS384 Management-Suite Software.

Authorization: Code holder (only code change), Master Code, Mutation Code
Requirement: System status “Unlocked” (door locks and door bolt open) 

To modify or delete existing codes, proceed as follows:

1. Wake up display (if necessary) and access menu.
2. Select and confirm the menu option “Code functions”.
3. Select and confirm the desired lock (e.g. lock 1).
4. Select desired code (e.g. “OCc1”) that you want to change or delete and confirm selection.
To Change a Code, proceed to step 5. To Delete a Code, proceed to step 10.
Changing codes
5. Select and confirm menu option “Change”.
6. Enter and confirm old Code (or Master Code or Mutation Code) for the selected lock.
7. Enter and confirm new individual code.  Note: If a code is changed to “10203040” (factory code), it is automatically deleted.
8. Enter and confirm again new code.
The new code is stored.
9. Repeat steps 5 through 8 for all codes of the selected lock that you want to change.
Deleting Codes
10. Select and confirm menu option “Delete”.
11. Enter and confirm old Code (or Master Code or Mutation Code) for the selected lock.
12. Confirm deletion of code.
The selected code is deleted.
13. Repeat steps 10 through 12 for all codes of the selected lock that you want to delete.