Error Messages When Opening the Locks
Note the following:
– To open a lock, you need one or two (Dual Mode) valid opening codes for the corresponding
lock.
– When an incorrect code is repeatedly entered when opening a lock, the locking system is
blocked for a certain time. The following penalty times are applied:
| Number of Consecutive Incorrect Code Entries | Penalty Blocking Time |
| 5 | 6 minutes |
| +1 (6th incorrect coe) | 6 minutes |
| +1 (7th incorrect code) | 6 minutes |
| +1 (8th incorrect code) | 6 minutes |
| +1 (9th incorrect code) | 10 minutes |
| +1 (10th incorrect code) | 10 minutes |
| +1 (11th incorrect code) | 10 minutes |
- If the Duress function is enabled, you can enter a Duress Code to open the lock in case
of a threat. The lock will open as usual according to the defi ned delay times, but a duress
alarm will also be triggered.
The Duress Code is formed by increasing the last digit of the Opening Code by 3 (examples:
Opening Code “13658792 -->Duress Code “13658795”, Opening Code“13658799 -->Duress
Code"13658702”, Opening Code“13658797 -->Duress Code “13658700” - there is no transfer
to the third last digit.)
Important: With the AS384 Management-Suite Software, the structure of the Duress Code can be modified. As standard, the Duress Code is activated and set to opening code+3.
- In Parallel Mode enabled, the Opening Codes for all door locks are identical. If door lock 1 with the Opening Code OCa1 is opened with enabled Parallel Mode, all valid Opening Codes can be used for the second door lock, except OCa1. To open any further door locks, all valid opening codes can be used, except the previously used opening codes.
The Parallel Mode is only valid for the door locks. Inner compartment locks can not be operated in Parallel Mode.
- If a non-return time delay, a fast locking period, or a holiday, weekly, or yearly locking period
is active, the display does not show "Open / Code Lock x" if the <Enter> key is pressed. With
the user profile editor of the AS384 Management-Suite Software, you can give a user the
right to interrupt a locking period. To be able to open the locks during an active locking period,
you have to open the Service menu. In the Service men,u select "Select lock -> Lock x ->
Open with x" to open the lock.