How to activate service user credential in E-Plex 36xx/37xx/56xx/57xx Series Locks?

Question

How to activate service user credential in E-Plex 36xx/37xx/56xx/57xx Series Locks?

Answer

A Service user’s credential (PIN) should be re-activated if it had been de-activated earlier - the procedure is very similar to the above procedure of activating an Manager or Access user.

Required User Level: Master

1. Put the lock into “LearnLokTM” Pushbutton Programming Mode - # Master PIN (or Manager credential) #
2. Enter Command 302# to re-activate a Service user’s credential; you do not need this person’s PIN and/or card to do this.
3. Enter this user’s ID location (001 through 300); we will use the ID location 125 in this example.
   Enter a last # to indicate the end of programming. 
   Example of Complete Entry for user ID=125:
   302#125# #.
   You have now activated this Service user’s credential which was temporarily de-activated.