How to add/modify an access user credential in E-Plex 36xx/37xx/56xx/57xx Series Locks?

Question

How to add/modify an access user credential in E-Plex 36xx/37xx/56xx/57xx Series Locks?

Answer

The procedure to add a Manager user is exactly the same as adding a regular Access user except for the different 3-digit command code 101 (instead of 100) usage. Also, only the Master can add, delete, etc, of the Manager users.

Required User Level: Master, Manager

1. Put the lock into “LearnLokTM” Pushbutton Programming Mode.
2. 2. Enter command 101# to add / modify a Manager User’s Access Credential
3. 3. Enter the User ID location NNN followed by #: NNN#; we will use 015# for example (Range = 001 to 300) 

4. a. Card Only Mode: After 101# 015# entry, present this Managers card close to the (black) card reader of the lock; the green LED flashes indicating that the card has been enrolled (added); enter # which confirms that this manager user is not assigned a PIN. You can add more cards by entering the next user’s ID location (NNN#) followed by presenting this next manager user’s card and then #; add up to 300 cards, if desired. 

   Enter a last # to indicate the end of programming. 
   Example of Complete Entry for manager user ID=015 
   101# 015# Present card # #.  

   b. Pin & Card Mode: Procedure is similar to step 4a above, but after enrolling the card you must not enter the # but continue with assigning the user’s PIN (4 to 8 digits as configured initially). 
   
   Example of Complete Entry for Manager user ID=015 and PIN=9876: 
   101# 015# Present card (no # entry here) 9876# 9876# (to re-confirm) #. 
   In the above examples, this Manager user’s card will open the lock if no PIN was assigned (card only mode), or the lock will open on entering the PIN first (9876) followed by presenting the associated card (PIN & Card mode). 

   5. The Manager User can also program the lock at the lock keypad like the Master user by putting the lock in “LearnLokTM” pushbutton programming mode as shown below. 

   Card only Manager: 
   # Present Manager’s card (no # key entry after) 3-digit command code #
   Continue with other desire program input sequence 
   End with the last # key to exit programming mode. 

   PIN & Card Manager: 
   # Manager’s PIN # Present Manager’s card (no # entry after) 3-digit command code # 
   Continue with other desire program input sequence 
   End with the last # key to exit programming mode.