How to Add/Modify a Manager Access Code in E-Plex 30xx/50xx?

Question

How to Add/Modify a Manager Access Code in E-Plex 30xx/50xx?

Answer

Each time you add a Manager access to a door, you must program the door with a Manager Access Code. If you change the Access Code for an existing Manager, the procedure is the same.

Required User Level: Master,

1. Put the lock into Pushbutton Programming Mode.
2. Enter command 101# to add / modify a User Access Code.
3. Enter the User ID location (a three-digit number you have on a list that you should carry with you) followed by #, for example 024#.
4. Enter UUUUUUUU#, representing a User Access Code of between 4 and 8 numbers, depending on the length of Access Code that you selected in Procedure 1 on page 7. For example, if your code length is 4 digits, the number could be 1224#.
5. Enter the code 1224# again.
6. Example of Complete Entry: 101#024#1224#1224#.
7. Enter another # to indicate the end of programming.
8. The Manager Access Code 1224 will now work in that door with all the access privileges assigned to a Manager User.
9. Manager Users can open the door by just entering the Access Code without the # signs, or put the lock into Pushbutton Programming Mode by entering # before and after their Access Code and program any lock.