Skip to main content
Find a Sales Rep

Open the lock with the factory combination in LA GARD Mechanical Combination Group 1, Group 2 & Group 2M Lock

Updated

How to Open the lock with the factory combination in LA GARD Mechanical Combination Group 1, Group 2 & Group 2M Locks?

Opening the lock – Using the OPENING INDEX 

The lock is shipped with the factory combination of 50. To open :

  1. Turn dial to the LEFT passing 50 at least five times then stop when 50 lines-up with the OPENING Index.
  2.  Turn RIGHT until dial stops, this will retract the bolt.
Figure 1 : GARD Mechanical Combination Group 1, Group 2 & Group 2M Locks?

NOTES: 

  • Variations in the alignment of the dial ring during installation could cause the Factory Combination of 50 to vary slightly, either up or down by one or two numbers.
  • If using the VisionGard Dial (2085 or 2090 Series) and a lock with the factory combination, the lock will open on 47.
  • When dialing a combination, if you passed the number on which you intended to stop, you cannot reverse the dial to correct. The opening procedure must be repeated from the beginning
  • You need to change the combination before putting the lock into operation.

Applies To

LA GARD Mechanical 4 Wheel Locks

Related to