What is the Installation Best Practice for Serviceable Dead Bolt?

1. A & B: Physically mount the keypad.
     Note: Do not install batteries or connect to power
2. C: Physically mount the lock body.
     Note: Do not pull or overstretch the keypad cable as it may be pulled out of the internal
              connection port.
3. Connect the keypad cable to the lock. 
    
4. Install batteries or connect power.
      Please Note: If programming lock and then shipping to site, disconnect power and do not
      reapply/insert battery power until all systems are mounted and properly plugged in. If keypad                      does not immediately respond, please allow 30 to 45 seconds for entry to properly pair with                          lock body.
     
5. Set Up: Open the container and follow the instructions on pages 19 to commission and set up
      your lock system.
      Note: The CenconX lock system is a combined hardware, software, and mobile solution. The
      complete installation and commissioning of your lock system will require coordination with the
      software administrator. See page 3 for details.                       

Applies To

CenconX