RT+ Mechanical Key Override, Key In Lever (KIL) Will this lock accept a competitor KIL cylinder? |
| The existing customer core can be adapted to work with our lock. The adapter part number is 068-14491. Please follow the instructions in the image below to swap the adapter out. Please note that the existing tailpiece may vary from the instructions. Some may only have 1 piece under the threaded nut. |
Applies ToRT+ |
F. K-I-L CYLINDER ADAPTOR ASSEMBLY INSTRUCTIONS
F-1 Adaptor A
Fits:
- Schlage Primus 20-724-XXX
- Schlage Everest 21-020-XXX
- ASSA V-10 Schlage key way
- Ilco 1599SC-XXX
Steps
- Remove key from cylinder
- Remove threaded nut (#9) by pressing down pin (#5)
- Remove tailpiece (#7) and any other plate or washer (#6 & #8), if applicable
- Be careful not to loose the pin and spring
- Replace with AdaptorA (#10) with small diameter facing upward
- Replace the threaded nut (#9) by pressing down pin (#5)
- Pin must be locked in a groove, if not unscrew until it reaches the closest groove test with key that cylinder rotates freely
- If not, press pin and unscrew one groove at a time and re-test
- The cylinder is now ready to be used
