Description

RCI introduces its new stainless steel push plate line. These push plates are designed to fit into standard electrical gang boxes, and/or RCI’s line of plastic enclosures. The faceplate is made of 1/16” thick stainless steel for durability and has concealed fasteners to minimize vandalism. The push plates may be hard wired to the access system, door operator or connected to RCI’s line of radio-controlled transmitters.

Note: If using transmitters, RCI recommends not using metal electrical boxes as this will reduce the range or effectiveness of the transmitters radio signal.

Installation Instructions

1. Wire the push plate to the door controller or radio-controlled transmitter using the NO or NC and COM contacts.

2. 

   Finger-tighten the enclosed hex-head screws into the electrical enclosure. 
   
   NOTE: The 6” Round, the 6” Square and the 4.75” Square push plates contain two different sized screws.
   The larger screws (#8) are for the corner locations on 4x4 electrical type boxes.
   The two smaller screws (#6) are for the single-gang or double-gang electrical type boxes.

3. Place the push plate holes over the hex-head screws. Use the enclosed hex key to fully tighten the screws.
4. Test for proper push plate activation.
   
   NOTE: Push plates will need an Adapter Ring (946DGPLATE) to use with RCI’s Double Gang Electrical Box.

Accessories

Plastic Enclosures: Wide Range of Surface and Flush Mount Electrical Boxes. 

Transmitters & Receivers: Range of Digital Transmitters and Receivers.

Bollard: Steel Mounting Post available in Black, Bronze or Silver for use with 4.5” Round & 4.75” Square Push plates.

Escutcheon: Stylish Stainless Steel Surface Mounting Box for 4.5” & 6” Round Push plates.

Cleaning

The push plates are constructed with durable stainless steel and painted with scuff-resistant coatings. To clean the plates, use only a damp, non-abrasive cloth. Regular cleaning with harsh solvents or abrasive materials may cause deterioration of the paint coating.