Configure the Input Signal as a Remote Disabled signal using Non-Display Keypads in LA GARD 700 Series Remote Disable

Question

How to configure the Input Signal as a Remote Disabled signal using Non-Display Keypads in LA GARD 700 Series Remote Disable?

Answer

Follow these steps to configure the Input Signal on a Non-Display Keypad:

1. Using the Keypad, input the following keystrokes:
   #16 + (Master ID and Combination) + (Input Signal Mode)* + (Enter key) 
   *(0 = Ignore, 1 = Remote Disabled, 2 = Remote Time Delay Override, 3 = Remote Dual User Override)
   As an example, if your Master ID was 00 with a Combination of 12345678, you would enter #1600123456781 to set up the Input signal for Remote Disabled.
2. The Keypad will beep three times and flash a green LED once complete.