How to Activate from FLM Mode to Route Mode in Cencon ATM Security Lock

Activation from FLM Mode to Route Mode

1. Initial FLM Unlock Steps

   Step	Action
   Power up lock	Turn the dial or power switch to activate the lock.
   EC	Enter the FLM combination to unlock the initial control panel.
   IPI	Insert the BLUE FLM KEY into the reader to authorize FLM mode.
   OPR	Turn the lock to the right to retract the bolt.
   Insert	Insert the Change Key to prepare for route activation.
   Extend	Extend the bolt fully to secure the lock in FLM mode.

2. FLM to Route Initialization Steps

   Step	Action
   Power left	The lock remains powered until EC is displayed on the panel.
   EC	Enter the sequence 50-25-50 to begin route mode setup.
   ISA	Insert and hold the RED SA KEY in the reader to initialize the lock.
   INI	Wait while the lock completes the initialization process.
   POC	Remove the RED SA KEY and pull out the Change Key.
   OPR	Turn the lock to the right to retract the bolt.
   Extend	Extend the bolt to complete this phase.

3. Record Close Seal - FLM Key

   Step	Action
   IPI	Insert the BLUE FLM KEY into the reader to verify FLM key entry.
   C00	Record and report the close seal for verification.

4. Activate Route Mode

   Step	Action
   EC	Enter the activation combination to enable route mode.
   IPI	Insert the BLUE FLM KEY or YELLOW ROUTE KEY to the reader.
   OPR	Retract the bolt by turning the lock to the right.
   Extend	Extend the bolt to complete the route mode activation.
   Power	Lock remains powered until IPI is displayed.
   IPI	Insert the BLUE FLM KEY or YELLOW ROUTE KEY to verify route key entry.
   C00	Record and report the final close seal.

Applies To

Cencon Lock (Swing Bolt)