How to Activate from factory to FLM and/or route modes in Cencon ATM Security lock

Activation from Factory Mode to FLM and/or Route Modes

1. Initial Power-Up and Change Key Setup (Factory Mode)

   Step	Action
   Power up lock	Turn the dial to power up the lock.
   EC	Enter 50-25-50.
   OPR	Turn the dial to the right to retract the bolt.
   Insert	Insert the Change Key.
   Extend	Extend the bolt.

2. Security Administrator Initialization and Mode Preparation

   Step	Action
   Power left	Turn the dial left until EC appears.
   EC	Enter 50-25-50.
   ISA	Insert and hold the RED SA KEY in the reader.
   INI	The lock initializes.
   POC	Remove the RED SA KEY and remove the Change Key.
   OPR	Turn the dial to the right to retract the bolt.
   Extend	Extend the bolt.

3. Final Activation to FLM or Route Mode and Close Seal Recording

   Step	Action
   EC	Enter the activation combination.
   IPI	Insert the BLUE FLM KEY or YELLOW ROUTE KEY into the reader.
   OPR	Retract the bolt.
   Extend	Extend the bolt.
   Power	Turn the dial until "IPI" appears.
   IPI	Insert the BLUE FLM KEY or YELLOW ROUTE KEY into the reader.
   C00	Record and report the Close Seal.

Applies To

Cencon Lock