How to do Keypad Setup - Network and End Point (Add Devices) in Axessor Apexx Software?

Question

How to do Keypad Setup - Network and End Point (Add Devices) in Axessor Apexx Software?

Answer

At the keypad, perform the following steps:

1. From the Advanced Menu, select the Network icon and press the Enter key.

2. Highlight Enable, then press the Enter key.

3. To enable network connectivity, use the directional arrows to highlight On, then press the Enter key.

4. Use the directional arrows to highlight Save, then press the Enter key.

5. From the Network menu, select View/Configure, then press the Enter key.

6. Verify that the network configuration details match those previously entered in the software. To change a setting, highlight it, press the Enter key, and use the numeric keypad to enter the correct information.

7. From the Network menu, select End Point (your communication server), then press the Enter key.

8. In the End Point sub-menu, select Edit Local End Point, then press the Enter key.

9. Use the numeric keypad to enter the Local End Point IP address of your communication server. Press the Enter key to advance to the next portion of the address. If you make a mistake, use the Back button to return and make corrections.

10. For the Commissioning Port, set the value to 5001, then press the Enter key.

11. For the MQTT Broker Port, set the value to 8883, then press the Enter key.

12. From the End Point sub-menu, select Mode (your communication server), then press the Enter key.

13. To set the connection mode, highlight Local Server, then press the Enter key.

14. Use the directional arrows to highlight Save, then press the Enter key.