How to use the Configurable I/O Table in Axessor Apexx Software

Question

How to use the Configurable I/O Table?

Answer

You can sort the device I/O's in ascending or descending order by clicking the "I/O" heading. A blue arrow will appear above the heading indicating the direction in which the devices have been sorted ().
To configure what each of the I/O are to be used for, click the Edit button (pencil) in the row of the table corresponding to the I/O you wish to configure.
Configure the behavior of the Input/Output by clicking the Normally Open / Normally closed button to toggle between the two states. indicates that the Input/Output will be open when the device is in its normal de-energized state and indicates that the Input/Output will be closed when the device is in its normal de-energized state.
Click the slider next to the option you wish to enable so that the slider moves to the right and turns blue , then click the Save button to store the change.

• Configurable Input Options
  
  • Remote Disabling - if this signal is asserted, the associated lock cannot be opened.
  • Door Contact - the input will act as the door contact associated with the lock. It will determine the open/closed state of the safe door.
  • Skip Time Delay - if this signal is asserted, you can skip the Time Delay period for the associated lock.
    
    
• Note: To skip the Time Delay period, this signal must be asserted prior to beginning the lock opening process.
  
  
• Configurable Output Options
  
  • Lock Open - when the associated lock is open, the output relay will open or close depending on how the output relay contact is configured
  • Time Delay Counting - when the lock's time delay period starts, the relay will open or closed depending on how the relay contact has been configured. The relay will return to its normal state when the Time Delay period has ended.
  • Confirmation Window Count - When the lock's Time Delay period ends, the Confirmation Window begins, and the relay will open or close depending on how the relay contact has been configured. The relay will return to its normal state when the Confirmation Window has ended.
  • Duress Code - this output will be triggered when a Lock User enters a Duress Code at the keypad.